There are 2 sponsors this month;
I have used Majestic Monarch Butterfly available here.
So how is it made? Piece of cake! I used some printer card I'd made during a session with our Molly. This was the shaving foam technique. Basically you get some cheap shaving foam onto a tray, add drops and splodges of inks; reinkers, starburst stains, anything like that. You can make patters or swirl randomly. Then you place your card on top, squish it down until the surface is covered, pick up and wipe off the excess foam (I washed it briefly under the tap) Set to dry and you have some nice coloured backgrounds.
I then just opened word and added the digi 3 times and printed out direct to the sheet. I've cut out and stuck one to the card base then 2 back to back then used glue dots to attach the body bit so the wings are 3d.
Thanks for looking :)
I'd like to enter into...
Crafty girls creations - Anything goes
Aud sentiments - anything goes+sentiment
Crafty gals corner - anything goes
Crafty addicts - bling it on
Classic design team challenge - Anything goes
3 comments:
Beautiful butterly.
Hugs, Angie (DT Sister)
Amazing technique you have used here on your Butterfly and it looks magic. Thank you for sharing your technique too. You creation turned out perfect. Love it.
Thank you for sharing with us over here at Classic Design Team Open Challenge and best of luck with your entry.
[Annette Registered Owner/Admin for Classic Design Team Challenge]
Fabulous shaped card, love that gorgeous butterfly. Thanks for sharing with us at Aud Sentiments and hope to see you again.
Hugs, Sandy
Post a Comment